Publicidad
Idiomas disponibles
Idiomas disponibles
10|English
Figure1: undo or remove the battery plug.
Figure2: check the level of acid in your battery. Top up with
distilled water if necessary.
Caution! Battery acid is corrosive, wash off acid splashes
immediately and thoroughly with plenty of water and
consult a doctor if necessary.
Danger! Hazardous electrolytic gas may arise during
charging. It is imperative, therefore, to avoid sparking and
open flames during charging. Risk of explosion!
Figure 3: First connect the red charging lead to the positive
pole of the battery.
Figure 4: Then connect the black charging lead to the
negative pole of the battery.
Figure 5: Once the battery is connected to the charger you
can connect the charger to a 220-240V/50-60Hz and
110-120V/60Hz
socket-outlet. It is prohibited to connect
the charger to a socket-outlet with any other supply voltage.
Figure 6: The only way to determine the exact condition of
the battery(level of charge) is to measure the acid density
with an acidimeter.
Please note: gases are released during the charging
Publicidad
