Publicidad
Idiomas disponibles
Idiomas disponibles
BLUETOOTH
The Bluetooth receiver can be used to establish a wireless connection to a Bluetooth signal
source (e. g. smartphone, tablet PC, notebook) and thus to replay the audio files stored on
the signal source via the ZZONE200SA
Establishing a Bluetooth connection:
1. Use the button MODE (21) to select the operating mode "Bluetooth" (Bluetooth shown on
the display): The display will show Initializing. . . and then Disconnected! to indicate that
no Bluetooth connection is established
2. At the Bluetooth source, switch on the Bluetooth function.
3. On the display of the Bluetooth source, the Bluetooth receiver will be indicated as
"Bluetooth". Pair the Bluetooth source with the Bluetooth receiver (please refer to the
Instruction manual of the Bluetooth source, if required).
4. Once the Bluetooth connection has been established, the display will show Connected!
5. Use the buttons of the Bluetooth source for operation (replay, pause, title selection) or
the button
(22) for replay / pause and the buttons
remote Control for title selection.
RADIO FM
Use the button MODE (21) to select the operating mode "Radio". The display will show:
– the FM frequency adjusted (in MHz)
– FM: 01 ... the station number under which the FM frequency has been stored by means of
the scan function
– the basic volume adjusted (VOL)
To store stations, press the button
The station scan will start. The transmission frequencies found will be automatically stored
as station numbers. When the station scan is completed, the frequency of station number 1
will be selected. To cancel the scan function at any time, press the button
To call up a stored station, either select the appropriate station number with the buttons
and
(24) or enter it by means of the numeric keys (29).
To manually set a station (in steps of 0.1 MHz), use the buttons F− and F+ (25).
Notes with regard to station number indication:
After manual frequency setting, the display will show FM: 00
– when the frequency set has not been stored as a station number
– when the frequency set has already been stored as a station number via station scan and
the reception quality is poor
The next time you switch to the mode "Radio", the display will not show FM: 00, but the
station number whose frequency is close to the frequency set, or, if no station number is
found, station number 1.
8
(22):
and
(24) on the
again.
Publicidad
