Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Electric Drill, 7/32" High Speed Steel Bit, Pencil, and Safety Glasses
1A. There are two slotted brackets attached to
the back of the glass door frame (at the top).
Attach a Key Bracket (E) to each of
the slotted brackets as in Figure 1A. Place
the glass door against the fireplace opening,
center it, and mark the lintel bar through the
slots in the Key Brackets (2 places). (A
second person may be necessary to
hold the door tightly against the fireplace
opening.) Remove the glass door and drill a
7/32" hole at each location marked. (Wear
your safety glasses while drilling.) Place the
glass door against the fireplace opening and
align the holes with the slot in each Key
Bracket (E). Use 1/4-20 x 1/2" Thread
Cutting Screws (B) to attach both Key
Brackets to the lintel bar.
2A. Insert 1/4-20 x 3 1/2" Thumbscrew (I) into
Pressure Bracket (H). Insert Pressure
Bracket (H) into the pair of holes closest to
the side of the fireplace opening. Making
sure the Thumbscrew (I) is pointing towards
the sidewall of the fireplace, tighten the
Thumbscrew (I) into the wall. Repeat on
opposite end.
ALTERNATIVE MOUNTING METHOD (for top of glass door)
ADDITIONAL TOOLS REQUIRED:
1A
2A
10
Publicidad
