Pleasant Hearth SL-4011BL Manual Del Propietário página 6

INSTALLATION INSTRUCTIONS
STOP! Please refer to our installation video at:
https://www.youtube.com/watch?v=reR-LUvl62g
Carefully remove all contents from the carton
and place the Fireplace Glass Door on a flat,
padded surface to avoid damaging the finish.
Always lift the door by the sides, not the top
frame. Check the included hardware against
the parts list.
If you are missing parts, please call GHP
customer service at 1-877-447-4768.
CAUTION: Before installing the Glass
Door, make sure the fireplace is cool.
1. This step may NOT be necessary!
The frame height (shown on Page 2) includes
a 1.5" riser bar. If your fireplace opening height
matches the dimensions noted below, DO NOT
ATTACH THE RISER BAR:
Model
SL-4011BL
SL-4012BL
SL-4013BL
SL-4014BL
SL-4015BL
SL-4016BL
If the riser bar is required, lay the door face
down on a flat, padded surface. Attach the
riser bar with two included Machine Screws as
shown in Figure 1. Use caution to protect your
hands from possible sharp metal edges. The
back edges of the riser bar and the back edges
of the bottom frame should be flush. In some
cases, the riser bar will extend in front of the
assembly frame which is correct.
NOTE: If your frame does not require a riser
bar, the riser bar and included hardware may
be discarded.
NOTE: In some models, a riser bar is provided with two sets of holes (top and bottom).
For proper flush fit, use the top or bottom set of holes, whichever are suitable to your
frame. Remember that proper flush means the back edges of the riser bar and the back
edges of the bottom frame assembly are even. In some cases, the riser bar will extend in
front of the frame assembly, which is correct.
Opening height
27 1/4"
29 1/4"
31 1/4"
27 1/4"
29 1/4"
31 1/4"
1
6
BOTTOM OF DOOR