MO-EL MO-FLAG 637M Uso Y Mantenimiento página 8

7. Keep the power cable away from heat.
8. Always disconnect the power supply before any maintenance
operation.
9. If the power cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
10. Do not spread any kind of flammable liquid, gas, or material on
the product.
11. This product is not suitable for use in barns, stables, or similar
places.
12. In the event of fault or malfunction, contact an authorised
Technical Service Centre and request original spare parts.
The electric insect killer is intended for indoor use only.
INSTALLATION
If the product is plugged directly into a fixed power line, a
bipolar differential circuit breaker with a contact opening
distance of at least 3 mm must be installed upstream of the
supply line. Before making the connections, make sure the
contacts in the breaker are open.
For added protection, we recommend installing a differential
current device with rated operating differential current
no higher than 30 mA on the electric circuit supplying the
product. Ask your installer for advice on this topic.
The special UV-A lamps are positioned to attract flying insects towards
the product. When the insects get close, they remain attached to the
adhesive paper. (Adhesive paper is supplied as a replacement part.)
This system makes it possible to control and eliminate flying insects
in the surrounding environment.
Place the electric insect killer preferably at a height of about 2 metres
in the darkest point of the room, away from windows.
The reason for this is that the product has to eliminate insects
inside the home and avoid attracting those outside. The wall should
be free of obstructions to allow easy removal of the adhesive paper
8