Publicidad
Idiomas disponibles
Idiomas disponibles
3. Clean outer surface of the filter using a
soft cloth to remove hair, dust, and large
particles.
NOTE: Do not clean the filter with water or
other liquids.
ONLY clean the pre-filter surface. Do not
clean the HEPA filter, and activated carbon
filter.
4. Clean out any remaining dust or hair
inside the air purifier using a vacuum
hose. Do not use water or liquids to
clean the air purifier.
There is a PM2.5 sensor at the back side
of the air purifier. It can be blocked by
dust, affecting the sensor's accuracy. It is
recommended to clean the sensor every 3
months.
If the air purifier is used in an environment
with more dust, you may need to clean the
sensor more often.
1. Unplug the air purifier. Carefully pry the
sensor cover with a flat head screwdriver
and remove the cover.
2. Use a vacuum hose to clean out any dust
inside the sensor area.
3. Install the cover back into place.
CLEANING & REPLACING FILTERS
CLEANING THE SENSOR
5. Replace the cleaned filters back
into the air purifier. See ASSEMBLY
INSTRUCTIONS (page 9).
6. If required, replace with new filters.
Unwrap the new filters from the
packaging and install them into the air
purifier. See page 7 for instructions on
how to order new filters.
7. Install the filter covers back into the air
purifier. See ASSEMBLY INSTRUCTIONS
(page 10).
8. Plug in the air purifier. Reset the filter life
as outlined in Filter Reset Button (page 12).
- 15 -
Publicidad
