JUMPSTARTER WITH COMPRESSOR
Introduction
To get the most out of your new energy
station, please read through these
instructions before use. We also recommend
that you save the instructions in case you
need to refer to them at a later date.
COMPRESSOR - WARNING!
Failure to abide by the safety regulations
in this manual may result in personal injury
or permanent damage to the jumpstarter's
compressor.
Always wear protective goggles when using
the compressor, as its operating pressure is
up to 18 bars.
Always follow the car manufacturer's or tire
manufacturer's instructions when infl ating
tires. Avoid over-infl ating the tires!
Always lock the compressor's nipple in place
on the wheel valve before turning on the
compressor.
The current pressure can be read on the
manometer.
The compressor may be used in intervals of
a maximum of 10 minutes. Thereafter, the
compressor must cool for at least 30 minutes
in order to prevent overheating.
26
STARTING AID - WARNING!
Failure to abide by the safety regulations in
this manual may result in injury or explosion.
Always wear safety glasses and read the
instructions before use.
The jumpstarter may only be used in
locations with suffi cient ventilation.
Turn off the car's ignition before connecting
the cables using the battery clamps.
The red positive (+) battery clamp and the
black negative (-) battery clamp must under
no circumstances come into contact with
each other.
Start by connecting the red positive (+)
battery clamp to the positive terminal (+) on
the battery. Then connect the black negative
(-) battery clamp to a chassis connection
in the engine compartment (exposed pure
metal, which is not one of the engine's
moving parts).
Unplug the black negative (-) battery clamp
fi rst once the engine has started.
Always make sure to wind the cables around
the holders on the jumpstarter.
The jumpstarter must be fully charged before
the fi rst time you put it to use.
Charge the jumpstarter after use and after
each particular jump start. Charge the
jumpstarter at least every other month. See
the section on "Charging".