KUNERT MATA Manual De Instrucciones página 10

WARNING This seat is not suitable for children under 6 months.
PRAM SEAT HOOD
The pram seat is equipped with a protective hood. To mount it, slide its hooks into designated slots on both
sides of the pram seat chassis until the hood is locked (fig. 13).
To remove the hood, press the buttons of the hooks on both sides and pull up the hood (fig. 13).The
position of the hood is adjustable. It can be positioned differently. To adjust the hood position, move it
forwards or backwards to achieve the desired result (fig. 14).If a new born baby is put in the stroller, it is
recommended to set the position of the seat which is to be used from the baby's birth in a position similar
to a lying one.
BACKREST ADJUSTMENT
The backrest can be adjusted in 4 positions. To lift the backrest up, you need to pull up the lever from under
the back of the seat and at the same time pull up the backrest up until you reach the desired position. Next,
release the lever (fig. 15).To recline the backrest, you need to pull up the metal lever, place it in the desired
position and release the lever.
SWIVEL FRONT WHEELS
The pram has front swivel wheels with a lock of the straight-ahead push. In order to lock the wheels, first
position them parallel to the rest of the pram and then turn the rim to the right (fig. 26). In order to unlock
the front wheels to go in all directions, simply turn the rim to the left.
FOLDING AND UNFOLDING THE PRAM CHASSIS
To unfold the pram chassis, lay it down flat (fig. 1) and pull it up strongly while holding the handle (fig. 2)
until the locking mechanism will lock into place (fig. 3).
WARNING! Before using the pram, ensure the locking mechanisms are activated, if not, pull them tighter.
The chassis may be folded in two ways (with and without wheels):
- to fold the chassis with the wheels, first lock the front wheels by positioning them across the to the pram.
Then pull the levers on both sides of the handle (fig. 4).
- to fold the chassis without wheels, take off two front wheels (fig. 5) and rear wheels
(fig. 6). Then pull the levers on both sides of the handle (fig. 4).
PARKING DEVICE
To activate the parking device, you need to step on the lever at the bottom of the pram (fig. 25). The
parking device will be released when the lever is lifted.
FOOTREST ADJUSTMENT
The footrest can be adjusted by simultaneously pressing side buttons while putting it in the desired position
(fig. 16).
MOUNTING AND REMOVAL OF REAR WHEELS
Before mounting the wheels, first mount the axes in the pram chassis. In order to mount the
axes, push the larger end of the axis into the absorber by pressing the red button, and then
release the button. Mount the axes on both sides of the pram and check whether fixed properly.
To mount the rear wheels, press the metal button in the central part of the wheel and then slide
the wheel on the axis as far as it will go, release the button and pull back the wheel until you hear
a "click" sound (fig. 6).Always check whether the wheels are mounted correctly. In case the pram
wheel comes of when pulled, repeat the wheel mounting procedure until mounted properly.
FASTENING THE HARNESS
In order to fasten the harness, click the ends of the harness in hooks on both sides of the carrycot. (The
harness is not provided with the pram).
GUIDELINES AND WARNINGS
- Before assembling the pram, ensure that all the components are fit to use. If they are damaged, the
product should not be used.
- When you fold and unfold the pram, ensure that the child is at a safe distance.
- The parking device must be used every time the pram is stopped.
- While adjusting the pram, you must ensure that no moving parts are directly touching the child.
- Any additional weight on the handle of the pram, the front/back of the seat and/or sides of the pram
10