Stanley STHT77616 Manual Del Usuario página 13

If the laser is NOT within its 4° compensation
range:
• The rotary laser beam does NOT rotate.
• On the keypad, FLASHES RED
(Figure Ⓗ ①).
• The laser is not level and must be repositioned
on a more level surface before use.
When you are finished using the laser tool in Self‑
7.
leveling Mode, press
Using Manual Mode
Manual Mode allows the laser tool to be positioned at
any angle. When in manual mode, the laser tool is not
guaranteed to be level.
Place the laser tool on a smooth, flat, level surface.
1.
Position the laser tool horizontally (Figure Ⓐ).
2.
Move the Lock Switch to the right to select Manual
3.
Mode (Figure Ⓜ ②).
Press to turn the laser tool ON.
4.
Do not look into the laser beams as they turn on.
5.
• The Rotary laser beam turns on and rotates 360°
(Figure Ⓐ ①).
• The Plumb Up Dot laser beam turns on from the
top of the laser tool (Figure Ⓐ ②).
On the keypad, make sure
6.
GREEN. If is flashing RED, the battery level is
low.
On the keypad, make sure
7.
(Figure Ⓗ ①)
Use the laser tool.
8.
When you are finished using the laser tool in
9.
Manual mode, press
to turn the laser tool OFF.
(Figure Ⓗ ②) turns
is solid RED
to turn the laser tool OFF.
Using the Vertical Position
Placing the laser in the Vertical Position repositions the
laser by 90°. When positioned vertically, the laser does
not compensate for an uneven surface. The laser is not
guaranteed to be level.
Place the laser tool on a smooth, flat, level surface.
1.
Position the laser vertically (Figure Ⓑ).
2.
Move the Lock Switch to the right to select Manual
3.
Mode (Figure Ⓜ ②).
Press to turn the laser tool ON.
4.
Do not look into the laser beams as they turn on.
5.
• The Rotary laser beam turns on and rotates 360°
(Figure Ⓐ ①).
• The Plumb Up Dot laser beam turns on from the
top of the laser tool (Figure Ⓐ ②).
On the keypad, make sure
6.
GREEN. If is flashing RED, the battery level is
low.
On the keypad, make sure:
7.
• is solid RED (Figure Ⓗ ①).
• turns ON (Figure Ⓑ ②).
Use the laser tool.
8.
When you are finished using the laser tool in the
9.
Vertical Position, press
OFF.
Performing Accuracy Checks
NOTE:
• The laser tool is sealed and calibrated at the factory
to the Rotary Laser Specifications listed in this
manual.
• It is recommended that you perform the accuracy
checks before using the laser tool.
• Be sure to allow the laser tool adequate time to
Auto-Level (at least 5 seconds) prior to performing
an accuracy check.
GB
GB
(Figure Ⓗ ②) turns
to turn the laser tool
13
E