Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Levelling the washer dryer
！
Warning!
• The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to the cabinet. If not, please turn them to
1.
their original positions tighten the nuts.
2.Loosen the lock nut turn the feet until it closely contacts with the floor.
3.Adjust the legs and lock them with a spanner, make sure the machine is steady.
Connect Water Supply Hose
！
Warning!
• To prevent leakage or water damage, follow the instructions in this chapter
• Do not kink, crush, modify or sever water inlet hose.
• For the model equips hot valve,connect it to hot water tap with hot water supply
hose. Energy consumption will decrease automatically for some program.
Connect the inlet pipe as indicated, There are two ways to connect the inlet pipe.
1.Connection between ordinary tap and inlet hose.
clamp nut
Loosen clamp nut and
four bolts
2.Connection between screw tap and inlet hose.
Tap with threads and inlet hose
1
Raise
1
Tighten clamp nut
2
Lower
2
slide bushing
Press slide bushing,
insert inlet hose into
connecting base
Special tap for washer dryer
9 10
3
Lock nut
foot
3
Connection finished
slide bushing
4
!
4
Publicidad
