MAINTENANCES
Cleaning Drain Pump Filter
!
Warning!
•
Be careful of the hot water!
• Allow detergent solution to cool down.
• Unplug the machine to avoid electrical shock before washing.
• Drain pump filter can filter the yarns and small foreign matters from the
washing.
• Clean the filter periodically to ensure the normal operation of washing
machine.
Open the lower cover cap
Open the filter by turning
to the counter clockwise
Caution!
• Make sure that valve cap and emergency drain hose are reinstalled properly, cap
plates should be inserted aligning to hole plates otherwise water may leak;
• Some machines don't have emergency drain hose, so step 2 and step 3 can be skipped.
Rotate lower cover cap directly to make water run into basin.
• When the appliance is in use and depending on the programme selected there can
be hot water in the pump. Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is empty. When replacing the
cover, ensure it is securely re-tightened.
1
Rotate 90°C and pull out
the emergency drain hose,
and take off the hose cap
4
Remove extraneous matter
2
Emergency
drain hose
5
10
26
After water runs out,reset
the drain hose
Close the lower cover cap
3
6