Flash Sanfil Thermoflash DIGI 2 HF Manual Del Usuario página 12

RF receiver installation
➀
Pushbuton for
configuration
and overide
➁
Network
presence
➂
ON/OFF output
display
Installation
Electrical connection
!
Before working on the installation, isolate all
electrical supplies.
All electrical wiring must be carried out by a
qualified person.
L
N
L N
5 4 3 2 1
Coding of transmitter with the
receiver
!
Important : the transmitter + receiver assembly
is factory coded and is therefore immediately
operationnal.
There is no need to recode.
1. Set switch 3 at the back
AUTO
of Thermoflash Digi 2 RF
3
to CONF position.
The display indicates CONF
CONF.
2. Press the pushbutton of
the receiver for more
than 3 seconds.
mémo
The indicator light OK
flickers.
3. Press the Thermoflash Digi 2 RF pushbutton
more than 3 seconds.
4. The indicator light OK of the receiver stops
flickering, showing that the transmission / reception
link has been established.
5. Return the switch located at the back of
the Thermoflash Digi 2 to the AUTO position.
For easier installation, the Thermoflash Digi 2 HF kit
is suppplied with a flexible 4-wire 1.5 mm
1.20m length (not connected).
We recommend using this cable for connecting
the HF receiver according to the following colour
codes:
Brown = phase
Blue = neutral
à
Gray
connection to the boiler
Black
L
N
L N
5 4 3 2 1
ON/OFF Priority settings
In the event of problem in your installation, the state
of the output can be priority set to ON or OFF.
Press shortly the receiver button (less than 3 seconds).
Each short pressing will change the output state.
To reset the receiver
• To remove all transmitter/receiver links:
- Press the receiver's pushbutton for more than 10
sec.
- The OK indicator light flickers slowly then more
quickly.
- Press again the receiver's pushbutton for 3 sec.
- The OK indicator light stops flickering and all codes
are removed.
ok on/off
The receiver switch back to «auto» mode.
• To remove one single transmitter/receiver link:
- Press the receiver's pushbutton for more than 10
+
for
sec.
- The OK indicator light flickers slowly then more
quickly.
- Using the decoding transmitter, press the «+» button
of the Thermoflash Digi 2 in CONF mode for 3 sec.
- The OK indicator light stops flickering and this
transmitter/receiver link is removed.
AUTO
The receiver switch back to «auto» mode.
3
CONF
Troubleshooting Guide
The heating system does not start.
• Receiver's power supply is cut off (OK light is off)
• Receiver is outside of transmitter's range
• Receiver does not recognise transmitter's code
• Receiver is disturbed by radio transmission (radio
ham, TV monitor, cellular phone re-transmitter, etc.)
• Transmitter is located in a disturbed area
In case of persistent problem, call on your
electrician.
2 cable of
L
N
Check fuse and circuit breaker.
Move transmitter closer to receiver.
Re-install receiver.
Attempt to remove the source of distur-
bance.
Move transmitter out of the disturbed
area.
L N
5 4 3 2 1