AquaPur AFR 3 A1 Instrucciones De Uso página 39

6) When you want to stop, switch the lint remover off using the
On/Off switch/Speed switch 5.
NOTE
Empty the fl uff collector 3 regularly. If the fl uff collector 3 is
overfi lled, the cutting blades will work more slowly even
though the batteries are not yet weak.
Removing/replacing the spacer
To attach the spacer 1, place it on the cutting head and
♦
GB
press it fi rmly.
MT
To remove it, pull the spacer 1 off with a slight twist.
♦
To protect the shaver foil 2, you should remove the spacer 1
♦
when not using the appliance and place the protective cap 6
on the shaver foil 2.
Cleaning and care
Emptying the fl uff collector
1) Pull the fl uff collector 3 off straight downwards.
2) Empty out the textile fl uff .
3) Replace the fl uff collector 3 so that it is fi rmly in place.
Cleaning the housing and cutting head
ATTENTION! MATERIAL DAMAGE!
Do not use abrasive, aggressive or chemical cleaning agents.
These could damage the surface of the appliance!
Clean the housing, the removed spacer 1 and the protective
♦
cap 6 with a moist cloth.
- 36 -