Publicidad
Idiomas disponibles
Idiomas disponibles
52
THERMEX Thermex Tx-series
INSTALLATION
Assembly and installation should only be carried out by qualified personnel who are familiar with applicable building regulations.
Ensure the following before installation begins:
•
The surface / table top where the unit is to be mounted must be horizontal and have sufficient space.
•
The surface / table top is sufficiently resistant to heat.
•
If the unit is mounted above an oven, the oven must have a built-in cooling fan or be insulated.
•
The installation must comply with the applicable rules and standards for installation, as well as the space requirements around the unit.
•
If there is any doubt about the applicable building element, it is recommended to consult the local authorities.
•
Always use heat-resistant cleaning agents on and around the unit.
Location of the device:
Cut out the hole in the table top according to the sizes shown in the drawing.
For installation and use of the hob, there should be at least 50 mm of space around the hole. This is to protect the table top material from the high
heat of the unit.
Make sure that the hob is well ventilated and that the air inlet and outlet are not blocked. Make sure the hob is in good working condition. As shown
below.
If the hob is installed above an oven, the oven must have a built-in cooling fan.
The installation must comply with all clearance requirements and applicable standards and regulations.
M 900211012207112022
Publicidad
