Publicidad
Idiomas disponibles
Idiomas disponibles
BS 18VC0 / BSS 18VC0
Torque preselection
CAUTION!
Change the torque only when the power tool
is stopped.
Move the torque setting turning dial to the
required position.
BS 18 VC0
:
1–23:
Screwing
:
Drilling
NOTE
The safety clutch is deactivated in the
Drilling setting
.
BSS 18 VC0
:
Speed preselection
CAUTION!
Change the speed only when the power tool
is stopped.
Move the selector switch to the required
stage:
1: Low speed, high torque
2: High speed, low torque
Switching on the power tool
To switch the power tool on:
Press the trigger switch.
The power tool trigger switch allows the
operator to increase the speed in
increments up to the maximum speed.
To switch the power tool off:
Release the trigger switch.
NOTE
The power tool is equipped with a brake
–
which stops the cutting accessory as
soon as the trigger switch is released.
When using the power tool continuously,
–
the operator should work primarily with
the trigger switch fully depressed.
Workplace lamp on/off switch
1. Turn direction of rotation preselector
switch (2) to "Forwards" or "Reverse".
2. Press electric tool on/off switch (1)
– Workplace lamp lights up
3. Release electric tool on/off switch (1)
– Workplace lamp goes out
automatically after approx. 10 sec.
Change single impact mode to impact
driver mode
Press mode switch for approx. 1.5 seconds.
– LED mode indicator lights up – single
impact mode active
– LED mode indicator not lit – impact
driver mode active.
Working with the power tool
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
21
Publicidad
