Pentair KREEPY KRAULY LIL SHARK Guia De Instalacion página 6

STEP 6 : Size the hose
For best results:
With the 'LIL SHARK™ Aboveground Pool Cleaner running
and submerged, pull hose to furthest end of the pool. The
hose should extend to the furthest point in the pool, plus
one section. Add or remove hose sections as needed.
Note: The hose is designed for use with the cleaner. Use of a
different type of hose will reduce the cleaner's performance.
STEP 7 : Pool coverage
Factory setting is set at #0. When watching the cleaner for the first time, adjust these settings to ensure complete clean-
ing coverage. See Fig. 5.
Fig. 5.
To remove Oscillator from cleaner, remove cover/skin by removing 2 screws on bottom of cleaner with phillips head screwdriver.
Tip cleaner on to its side, support side of housing, and tap axle shaft out of body.
Oscillator will now slide out of cleaner body. Oscillator impact bumpers can be pried out of slots in cleaner body (they slide
towards bottom of cleaner). To replace, reverse procedure.
G-INSB-LILSHARK (REV 01/2015)
Large Circles
Clockwise
Oscillator Removal
Moderate Circles
Clockwise
Tight Circles
Clockwise
6