Power Dynamics PDC-40 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONNECTING WITH BT-DEVICE
1.
2.
3.
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
CONTROLS AND CONNECTIONS
Front View:
1. STAND-BY BUTTON
Use this switch to put the unit into or out of standby mode.
2. REMOTE SENSOR
This sensor receives the infrared information from the remote control. Don't place any object or sticker in front of the sensor.
3. MODE BUTTON
Press to change modes between playing USB stick, auxiliary input, Bluetooth, DAB+ and FM.
4. MENU BUTTON
Press to enter FM / DAB+ menu mode. If the user does not select any item by pressing ENTER knob, it will return to FM /
DAB+ playing after several seconds.
FM menus consist of "Audio setting" and "System".
"Audio setting"
a. Forced mono: As a stereo signal becomes weaker the audio signal will become poorer. It may be preferable to force the
radio to play the station in mono in order to reduce the level of audio noise.
b. Stereo allowed: "St" indicator on LCD display means that the current station is played as stereo.
Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Press the "MODE" button and activate BT-function.
Select "PDC40" on your BT-device and make the BT-connection
3