Velleman VDPDMXDP134 Manual De Instrucciones página 3

b) Back Panel
10. DMX output (3-pin female XLR)
11. DMX input (3-pin male XLR)
12. Analogue output (0-10Vdc)
13. Analogue input (0-10Vdc)
14. Load connection box
c) Connections
Single-phase power input
Remove the cover of the load connection box and connect the mains and the load to the device
according to the figure above.
5. Operating Instructions
Manual Control : Manual control is possible through the channel faders if neither an analogue
or DMX controller are used. Slide them up or down to adjust the output
(dimming level) for each channel.
Preheating : Enables you to adjust the min. output level (between 0-50%), which
enhances the life of the lamps.
Analogue Input : Connect the analogue controller according to the diagram below. The device
supplies the controller with DC power.
DMX Input : The dimmer pack can receive DMX512 signals. Adjust the DIP switches to
confirm the start address of the device. When the 10
ON-position and you move one of the sliders, then all channels will react
simultaneously and they will all be placed at the same level.
VDPDMXDP134
Three-phase power input
3
th
switch is placed in the
VELLEMAN