Metabo HPT UC 18YFSL Manual Del Usuario página 10

English
(3) Regarding recharging time
Table 4 shows the recharging time required according to the type of battery.
Battery Capacity
1.3 Ah
1.5 Ah
2.0 Ah
2.5 Ah
3.0 Ah
4.0 Ah
5.0 Ah
6.0 Ah
NOTE: The recharging time may vary according to the ambient temperature.
4. Disconnect battery charger from the receptacle.
CAUTION: Do not pull the plug out of the receptacle by pulling on the cord.
Make sure to grasp the plug when removing from receptacle to avoid
damaging cord.
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull out the battery from the battery charger.
NOTE
Be sure to pull out the battery from the battery charger after use, and then keep it.
Regarding electric discharge in case of new batteries, etc.
As the internal chemical substance of new batteries and batteries that have not been used
for an extended period is not activated, the electric discharge might be low when using
them the fi rst and second time. This is a temporary phenomenon, and normal time required
for recharging will be restored by recharging the batteries 2 – 3 times.
How to make the batteries perform longer.
○ Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and recharge
its battery. If you continue to use the tool and exhaust the electric current, the battery may
be damaged and its life will become shorter.
10
Table 4 Recharging time (approx. min.) at 20°C
14.4 V
—
BSL1415
BSL1415X
—
BSL1425
BSL1430C
BSL1430
BSL1440
BSL1450
—
Li-ion BATTERY
Battery Voltage
—
BSL1815S
BSL1815
22 min.
BSL1815X
—
BSL1820
35 min. BSL1825
45 min. BSL1830C
45 min. BSL1830
60 min. BSL1840
BSL1850
75 min.
BSL36A18
—
BSL1860
18 V
22 min.
22 min.
30 min.
35 min.
45 min.
45 min.
60 min.
75 min.
90 min.