Installation; Operating The Machine; Ergonomic Model - Rosito BisanI Synchro 2gr Manual De Instrucciones

INSTALLATION

1. Remove the coffee machine from its parcking
and check that it has not been damaged. Level
the coffee machine by adjusting its feet. Check
that the voltage of your mains supply corresponds
to that indicated in the technical specifications.
2. Place the appliance on a stable top, close to the
mains sockets and water line connections.
3. Connect the drinking water delivery pipe
(3/8"). Only use a certified pipe suitable for
drinking water complying with D.M. 21.03.73.
Connect the drainpipe to the plastic container.
(Comply with the regulations set by the rele-
vant institutes of each state, region or country).
OPERATING THE MACHINE: Switch to pos. 0
1. Turn off the water delivery tap and check for
leaks.
2. Rotate the switch knob to position 1.
3. The coffee machine will automatically be filled
with water up to the pre-set level (level probe
inside the boiler). These coffee machines also
have a manual filling function, as they can be fil-
led with water by rotating the knob of the inter-
nal tap.

ERGONOMIC MODEL

1. Turn off the water delivery tap and check for
leaks.
2. Rotate the knob of the internal tap located
below the tank and check that the water level is
more than the minimum quantity and less than
the maximum quantity (as indicated on the level
indicator).
3. Start the red switch near the level indicator.
Wait approximately 30 minutes to allow the
machine to reach its operating temperature. The
4. Connect the power supply wire (type H07RN-
F 5x2,5 mm ) either to a certified industrial
2
three-phase socket, 16A 400V˜3N+EARTH or to
the terminals of a multipolar certified I-O main
switch, fitted with 16A fuses, installed upstream
(distance of contacts ≥ 3mm). Installation has to
be performed by qualified personnel, in com-
pliance with these instructions and with the
General Regulation on electric plants CEI 64.8.
Before starting the coffee machine, check that the
mains socket is fitted with an EFFICIENT AND
SAFE GROUND CLAMP: check ground system
efficiency.
N.B.: Electronic models are fitted with a safety
level indicator. If the machine switches off during
filling and the LEDs on the console blink, follow
the instructions under ELECTRONIC DOSING
(refer to chapter 6 A.)
4. Once the machine has been filled to the preset
level, move the switch to 2 (wait approximately
30 minutes to allow the machine to reach its ope-
rating temperature. The coffee machine is ready
use when the geen neon indicator goes off.)
coffee machine is ready for use when the green
neon indicator goes off.
4. It is recommended that the boilers is filled
before switching the machine on. (otherwise the
heating element in the boiler will burn because of
the absence of Water).
Ch. 3
Carefully read
the instructions
opposite.
Ch. 4
Ch. 5
Steam and
water are under
pressure.
SCALD
HAZARD
Page 2
GB
The coffee machine
is automatically filled
with water up to the
set level.