N'oveen IWH150 Manual Del Usuario página 14

Method of use
1. Water temperature control handle
As shown in the figure, the lever has a rotation range
of 150 °, the hot water area is 60 °, the cold water
area is 60 °, the middle area 30 ° is the lack of water.
The battery operates on the principle of heating the
flowing water, the higher the flow of water, the lower
its temperature. Just move the lever gently to the hot
water area and the battery will turn on, the flowing
water will be heated up.
2. Use of water through a shower head
To use the handset in the shower mixer pull the
adapter (fig.3) and water from the battery will be directed to the handset. To stop the water, push
the adapter.
3. Temperature display
The display shows the water heating temperature, and the battery operating status - heating /
no heating. The temperature of the water itself may differ from the one shown on the display.
Moving the lever into the cold water area will turn off the display.
4. Cleaning the aerator
Unscrew the aerator, rinse it under high pressure water, if you can not clean the inside of the
aerator, use a needle.
5. Cleaning the heating pipe
Open the lid, gently clean the tube with a toothbrush, and then rinse it with water as shown in
the figure below. Remember to disconnect the power before cleaning!
14