Installing Memory
Module
About Memory
Memory, is something like the desk. When the top of the desk is wide, your job is easy to do. When entire capacity of
memory is large, the operation of application software becomes smooth.
Work Flow for Memory
Installation
● Turn off the Notebook
● Remove battery pack and AC adapter
● Memory Installation ( Page 44)
●Verify the memory installed (Page 44)
Pay attention when handling memory module
*Before installation, please turn off the Notebook
*Before installation, please remove the battery pack and AC adapter.
*Memory is the extremely weak part in static electricity. It is possible to damage it when people
Attention
or objects touch it with static electricity. Please remove static electricity of the body before
touch ( Page 43)
*DO NOT touch the pin of memory. It is possible to cause memory broken by pin contact failure.
* Memory is a extremely weak part, please keep or remove it carefully.
42
qbex aero style / User's guide
When the memory is small
Exchange Memory
1
Close the LCD lid and turn over the Notebook.
2
Remove the screw which locks the memory
module cover.
Slide the memory module cover forwar
3
(
) Raise and remove the cover (
)
1
2
1
Open the hook which locks memory
4
2
Remove memory from the memory slot
qbex aero style / User's guide
When opening the hook, do not
apply unreasonable force and do
it prudently. When the power is
Notice
applied too much, It is possible
tobend the hook.
5
Insert new memory module to the connector of
the memory slot
1
Push down and insert the memory to the memory
slot connector until the "click" sounds.
2
*Please make sure not insert the
memory in the wrong direction.
*Please make sure the notch on
memory's lower part is agreeable
Notice
to the convex section of the slot.
Install the memory module cover, lock
6
with the screw.
Please do not break the nail
on the right side of the memory
module cover surface when
you install the memory module
Notice
cover.
Install battery pack and connect AC
7
adapter.
43