Acer ES 5 Serie Manual Del Usuario página 10

• Do NOT ride through puddles or any other (water) obstacles. In such a
case please lower your speed and bypass the obstacle.
• DO NOT carry any passengers. The electric scooter is for one rider only
• Do not carry a child.
• Do not ride when pregnant.
• DO NOT use mobile phone or wear earphones when operating the
electric scooter.
• DO NOT touch the hub motor after riding because it can get hot.
• Always keep both hands on the handlebar or you risk serious injury due
to loss of balance and falls.
• Only for use in dry weather.
• We do not recommend the use on public roads.
• Never turn violently when driving fast.
• Do not start or stop suddenly.
• Make sure the speed of the electric scooter is safe for you and others
and be ready to stop at any time while it is running.
• When driving the electric scooter, please stay at a distance from others
to avoid collisions.
• When you turn you must use the center of gravity of your body; the
violent change in the center of gravity can cause damage.
• Routinely check the bearings for moisture and dirt. Dry and clean the
bearings. If necessary, grease the bearings after cleaning. Only sue
suitable lubricants for this purpose. Also check the steering position to
ensure this product is safe.
•
made.
•
• Avoid driving on steep slopes.
VIII. CLEANING AND
MAINTENANCE
This electric scooter can be used as a means of transport and as such
due to the use of the same and is not covered by the warranty.
CLEANING
Make sure the electric scooter is powered OFF, the charge cable is
unplugged, and the rubber cap on the charge port is tightly sealed
before cleaning; otherwise you may damage the electronic components.
with the battery, motor and other electronic parts during cleaning to avoid
unforeseen hazard. Do not use a high pressure water jet to clean the
product or soak it in water.
To clean the electric scooter, use a damp cloth. If you need to scrape dirt,
use a soft brush and then a damp cloth.
Be sure to cover the charging port to avoid problems with the electronic
components.
Do not use alcohol, gasoline, kerosene or other volatile or corrosive
chemical components. This can damage both the appearance and the
internal structure of the electric scooter. Also, do not use a pressure water
gun or running water.
CONSERVATION
Store the electric scooter in a cool, dry environment when not in use.
Avoid leaving it outside, since it is not manufactured for use in wet
areas, near corrosive agents such as seawater, ports, etc. It is also not
recommended to expose it to high temperatures caused by direct sunlight
for a long time.
EN-9