Publicidad
Idiomas disponibles
Idiomas disponibles
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Make sure the container is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blower port on the backside of the power head. (fig. 2)
5. Ensure the power switch is turned off and plug into the power supply. (fig. 3)
6. Before turning on the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch to
the 'I' ON position. (fig. 4)
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Disconnect the hose from the vacuum. (fig. 2)
3. Undo the latches and remove the power head from the container. (fig. 3)
4. Clear all dirt or debris from the container and hose. (fig. 4)
For filter changing and maintenance see instructions on page 10.
IMPORTANT!
Clean or change the dust filter regularly for best performance. ALWAYS USE A DUST
FILTER FOR DRY VACUUMING. If the machine is used with out the dust filter, the motor will burn out and
the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filter included is made of high quality material designed to stop small dust particles. The
filter should be used for dry pick-up only. A dry filter is necessary to pick up dust. If the dust filter is wet, it
will clog quickly and be very difficult to clean. Handle the filter carefully when removing it for cleaning and
replacing it. Check the filters for tears or small holes, a small hole can let dust pass through and out of the
cleaner. Do not use a filter with holes or tears; replace the filter immediately if a hole or tear is found.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING
THE POWER HEAD FROM CONTAINER. ANY OTHER SERVICING SHOULD BE PERFORMED BY AN
AUTHORIZED SERVICE REPRESENTATIVE.
BLOWER OPERATION
MAINTENANCE
9
Publicidad
