Glacier bay BTH-018-112 Guía De Uso Y Cuidado

TOOLS REQUIRED
Electric drill
Level
Installation
1
Determining the mounting
location
Tape the template to the wall with masking
tape and ensure it is completely level
Use a level to determine the location where
you want to install your accessory.
Phillips
Claw
screwdriver
hammer
Template Masking Tape
2
Drilling the pilot hole
Pre-drill a pilot hole with a small drill
Safety Information
If installing into ceramic tile, before attempt-
ing to drill through ceramic tile, the following
must be done:
Using a center punch, very lightly and
carefully tap the spot where you wish to drill
to break the shiny glass portion of the tile.
USE AND CARE GUIDE
HARDWARE INCLUDED
A- Self-drilling
B- Mounting bracket
drywall anchor
x4
D- Hex wrench
x1
1
Please contact 1-855-HD-GLACIER for further assistance.
Item #100-489-2488
100-489-2489
Model #BTH-018-112
BTH-024-113
TOWEL BAR
C- Mounting screw
x2
E- Set screw F- Solid wall anchor
x2
3.1
Installing the bracket in
drywall
Drill a 1/8 in. based on the pre-drill pilot hole.
Drive the drywall anchor (A) into the wall using
a Phillips screwdriver until ush with the wall.
Align the mounting brackets (B) with the
drywall anchor (A) and secure with the
mounting screws (C).
NOTE: To install the brackets (B) in a wood
stud, proceed to Step 3.2. To install the
brackets (B) in ceramic tile, proceed to Step 3.3.
3.2
Installing the bracket in
wood stud
Drill 3/32 in. based on pre-drilled pilot hole.
Align the mounting brackets (B) with pilot
holes and secure with the mounting screws
(C).
HOMEDEPOT.COM/GLACIERBAY
x4
x4
A
B
C
B
C