Mc Haus artic-22 Manual página 43

MAINTENANCE
WARNING! Before cleaning, please turn off the air conditioning and disconnect the plug.
CLEANING THE SURFACE
Clean the surface of the air conditioner with a cloth or a soft, semi-damp cloth. Do not use chemical reagents. Doing
so will damage the surface of the unit and may even damage the air conditioner completely.
CLEANING THE FILTERS
If the air conditioner is used continuously, it is recommended to clean the filters once every two weeks.
1. Remove the air inlet grille and pull the filter screen out from both sides according to the direction
shown in the following figures.
2. Put the filter screen in the hot water (approximately 40°) added with neutral detergent, dry it in a
shaded place after cleaning.
TROUBLESHOOTING
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly. The table includes some of the most common
problems, their causes and remedies.
PROBLEM
It's not plugged in.
The air
Incorrectly set timer
conditioning
FL" appears on the display panel.
doesn't work
The protector has been activated
Air inlet/outlet obstructed
Other heat sources in the room.
The cold/heat
Filters that are too dirty.
effect is not good
Improper temperature setting.
Fan speed set to minimum.
Sloping structure.
Too much noise
and vibration
Irregular floor.
WARNING! When the following anomalies occur in the air conditioning system, switch it off and remove
the plug. Then contact the Official Technical Service.
Mc HAUS
CAUSE
artic-22
SOLUTION
Insert the plug firmly.
Change the time setting. The air conditioner
can be restarted 3 minutes after it is turned
off.
Empty the water tank and restart the air
conditioning.
Wait 3 minutes and turn on the machine
again when its temperature decreases.
Remove the obstruction.
Remove the other heat sources.
Clean the filters.
Change the temperature.
appropriate speed.
Place the air conditioner on a regular
surface.
EN
Select the