Publicidad
TO ASSEMBLY BAGGER
•
Unfold bag and stand right side up.
•
Feed front bagger frame (1) up through fabric loops at each
side of bagger.
•
Snap bottom of front bagger frame (1) into snap feature at
front of bagger bottom.
•
Slide bagger fabric loop (2) segments at the ends of bag
onto top bagger frame tubing.
•
Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the front of
top frame.
•
Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through holes
at top of the front bagger frame and thread into nuts inside
the tubing of top bagger frame.
1
•
Uninstall (1/4"-20) lock nuts (4) at bottom of front bagger frame.
•
Unfold cross braces (5) and attach to carriage bolts at bottom
corners of front bagger frame.
•
Reinstall (1/4"-20) lock nuts (4) and tighten until fully seated.
5
•
Remove clevis pin (6) and retainer spring (7) from bagger
handle (8).
•
Slide bagger handle (8) down through bagger cover and
frame upper weldment holes.
•
Reinstall clevis pin (6) through hole at bottom of bagger
handle and slide retainer spring (7) into hole at the end of
the clevis pin until it locks into place.
7
3
4
8
6
TO INSTALL BAGGER SPRING LATCH
The bagger spring latches are located on the back plate (1),
one in each of the bottom corners.
•
Before installing, tractor engine must be shut off and parking
brake engaged.
•
Install each bagger spring latch with the loop end (2) down
and facing towards the bagger assembly.
•
Place the mounting bolt (3) through the curved end of the
bagger spring latch, through the back plate, and secure with
nut (4) as shown. Tighten firmly.
3
•
The bottom of the bagger assembly should contact the loop
end so that it is held securely when closed.
2
TO ADJUST BAGGER FULL LEVER/PADDLE
•
Before adjusting, tractor engine must be shut off and parking
brake engaged.
3
•
For the heaviest/wet grasses, remove paddle (3).
•
For lighter grasses use the paddle (3) on setting "1", "2", or
"3" ("3" being for the lightest or dry grass).
•
Choose your setting and rotate the bagger paddle (3) so that
the desired number (setting) faces you.
•
Setting may be changed by loosening fasteners (4 and 5),
removing/rotating paddle (3), and tightening again.
25
4
2
1
2
1
4
3
2
5
Publicidad
