Denver TSP-203 Manual De Usuario página 6

10. Battery shall not be exposed to direct sunlight or fire.
11. Do not attempt to replace the battery. For repairing and servicing, please consult
from the store of purchase or customer service centre designated by the store.
CAUTION: Danger of explosion if battery is incorrectly replaced.
12. Do not use any other power supply other than the one specially designed for this
product.
13. Keep this operating instruction in a safe place.
14. Contact an authorized service centre if you have any inquiry about this product.
POWER CONNECTION
- Unpack this product, ensure
the power ON/OFF switch is
on "OFF".
- Connect the supplied AC
adaptor to this product, plug
the AC adaptor to the wall
outlet.
RECHARGING
- Unit comes with a battery indicator
alert.
- If Battery LED flashes, it means the
battery level is low and recharging is
required.
- By connecting the AC power, the
Battery LED will turn red, it means
the unit is under recharging.
- When the Battery LED becomes green, it means the battery is fully charged.
It is recommended to charge the battery about 6 hours before you start using
the unit for the first time.
Energy Saving: If this product is idle for about 20 minutes, it will go to
standby mode automatically. It will auto power off
Caution: To keep the rechargeable battery in good condition, users should check
the unit and be sure to turn the Power On/Off switch on the back panel to "Off" every
time after using and before storage, it is highly recommended that users should fully
recharge the battery at least once every two months.
BLUETOOTH CONNECTION
- Once the power switch is turned to "On", Bluetooth "BT" mode is set as default
- Blue LED indicator will be flash in pairing mode. The red LED display will show "bt"
EN-4
POWER
ON OFF
LINE IN DC JACK
USB 1A CHARGER
MIC 1 MIC 2