Publicidad
Idiomas disponibles
Idiomas disponibles
6
Lopper Magma E-100/E-140 TR
Please check that the electric lopper and batteries are clean and dry.
Place the battery onto the loppers'body by sliding it downwards until it clicks-in. To disconnect
the battery, push the two lateral buttons and pull upwards.
7
Operation modes
Automatic cutting: The blades close completely whenever the trigger is pulled by the operator.
By releasing the trigger, the blades reopen completely.
Security blade's lock: it allows locking the blades in order to avoid that they open when the
trigger is pulled accidentally.
124
Art. 612 / Art. 613
Lopper Magma E-100 and E-140 TR
Assembly
Usage
Art. 612 / Art. 613
Lopper Magma E-100 and E-140 TR
Usage
Operating instructions
Automatic cutting:
1.
Push the ON/OFF switch and wait for the audible tone (1 bip, 1 bip-bip-bip) to release.
2.
The lopper will emit an acoustic signal (1 beep) to indicate the release of the blades, which
will however remain closed. Press the trigger again twice to open the blades, the lopper
will emit another beep (1 beep).
3.
The lopper now automatically work in automatic cutting mode. It is now possible to start
working.
Manual activation of the security lock/unlock of the blades:
1.
To activate the security lock of the blades, keep the trigger pulled until the lopper emit an
audible tone, followed by other three repeated audible tones (1 beep, 1 beep-beep-beep).
With this operation, the blades close. By pulling the trigger, the blades don't move.
2.
To deactivate the security lock of the blades, quickly pull the trigger twice, repeatedly. The
lopper emit and audible tone (1 beep) and the blades open to maximum aperture. Now the
blades close whenever the trigger is pulled.
For further information about the product, please contact info@stockergarden.com
7
125
Publicidad
