Descargar Imprimir esta página

Truper CALA-A5-2 Instructivo página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

Technical data
Code
Description
Voltage
Frequency
Current
Power
Speed
Cutting capacity
Duty cycle
Conductors
Insulating
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING
Before gaining access to the terminals all power sources should be disconnected.
Power requirements
WARNING
Tools with double insulation are equipped with a 220 V~ plug.
Do not alter the plug in any way. Double insulation eliminates the need of a
grounded third power cord with three prongs or a grounded power connection.
"The male connection plug may only be connected to a socket of the same
technical characteristics of the plug on"
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in
power loss and overheating. The following table shows the right size to use depending on cable's length and the
ampere capability shown in the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 11 A
from 11 A and up to 15 A
from 15 A and up to 17 A
from 17 A and up to 23 A
30 minutes work per 15 minutes idle. Maximum 3 hours per day.
H05VV- F 2 x 0.75 mm² with insulating temperature of 221 °F
Class II
Number of
Conductors
3
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
CALA-A5-2
15469
Jig saw
220 V
50 Hz / 60 Hz
3,2 A
1 Hp
800 - 3 000 run / min
Wood 3,93" | Metal 0,39"
IP Grade
Power Cord Grips: Type Y.
Build Quality: Reinforced Insulation.
Thermal Insulation on Motor Winding: Class E.
Authorized Service Center.
Extension gauge
from 5.9' to 49.2' |
18 AWG( * )
16 AWG
14 AWG
10 AWG
IP20
higher than 49.2'
16 AWG
14 AWG
12 AWG
8 AWG
ENGLISH
3

Publicidad

loading

Este manual también es adecuado para:

15469