Publicidad
Idiomas disponibles
Idiomas disponibles
13. ALwAYS secure workpiece in a vise
or clamp.
14. NEVER point an air tool at oneself
or any other person. Serious injury
COULD occur.
15. ALwAYS work in a well
ventilated area and wear
OSHA approved dust mask.
16. Use ONLY sanding pads
rated at or above the tool's
RPM.
Check sanding pad for cracks
and wear prior to use. Replace
if damaged. A damaged pad can break
apart during use and cause serious
injury.
17. Ensure sandpaper is fully sealed onto
sanding pad and that pad is securely
tightened to tool spindle.
18. Do NOT free spin tool. Acuate trigger
just before engaging work surface
and release trigger when lifting tool
away from surface.
Figure 1
Assembly
set-up InstRuctIons
Air tools require a supply of clean, dry air
at 90 PSI (6.2 bar). An air supply system
with filter, regulator, and lubricator (FRL)
as shown in Figure 1 should be used.
Campbell Hausfeld FRL model PA2104
(3/8 inch) or PA2114 (1/2 inch) is
recommended.
MAX
MAX
water in the air supply can damage the
RPM
RPM
tool. Drain condensate from compressor
tank and filter daily.
All hoses and fittings must be the correct
size and tightly fastened. Refer to Chart 1
for minimum sizes.
Option 1: Individual components
Filter
Regulator
Option 2: 3 piece combo
Filter, Regulator, and Lubricator
www.campbellhausfeld.com
Cl156500, Cl156700
Tool Air Consumption
Less than 9 SCFM @ 100% usage
9 to 34 SCFM @ 100% usage
Greater than 34 SCFM @ 100% usage
Chart 1 - Suggested minimum hose diameter to
use based on 50 ft length hose and continuous
SCFM rating of tool. The use of fittings and longer
hose may require a larger diameter hose to be
used.
Lubricator
Hose ID
1/4 inch
3/8 inch
1/2 inch
3
Publicidad
