Descargar Imprimir esta página

Avintage AVU8TNA Manual De Utilización página 42

Ocultar thumbs Ver también para AVU8TNA:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 98
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-20°C
or 5-10°C/10-20°C (depending on the model).
• "RUN"
Power indicator
button
To turn the appliance on or off.
Press and hold this button for around 3 seconds.
button
Inner lighting control button
• Display
Electronic temperature display
button
+ temperature setting button
button
- temperature setting button
• You can choose the desired chamber temperature by using the "
selected increases/decreases by 1°C with each button press.
Temperatures between 5 and 20°C or between 5 and 10°C / 10 and 20°C (depending on the model) can
be selected. Once the desired temperature has been selected, the display will flash for 5s before showing
the current internal cooler temperature. The set temperature can be viewed at any time by pressing and
holding the temperature select buttons for 5s.
In the event of a power cut, all previously selected temperature settings will be deleted and each chamber
will re-initialize to the factory-preset temperature of 12°C.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take
around 30 minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same
circumstance, it will take around 30 minutes to decrease the wine cooler's temperature from 12℃
to 5℃. The less the temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
/
" buttons. The temperature
42

Publicidad

loading

Este manual también es adecuado para:

Avu8txa