A battery placed on damp ground or grass could be electrically shorted. Lay the battery on its side when not in use.
Do not store batteries above 140°F (60°C) for extended periods.
Failure to observe these warnings could result in injury or damage to the battery from rapid discharge of energy or
overheating of the battery.
Electrical Shock Hazards
The following precautions should be observed to avoid the risk of electrical shock hazards associated with charging
batteries:
The MX5 Multi-Charger has been designed for indoor use only. Do not operate outdoors or in extremely high
humidity environments. Do not expose charger/analyzer to rain, snow or wet conditions.
Unplug the charger/analyzer from power source before cleaning. Use only mild detergent with a slightly damp
cloth to clean the outside of the charger/analyzer. Do not use solvents or flammable cleaners. Allow the case to dry
fully before using again.
Use of attachments or accessories not recommended by LXE could result in fire, electric shock or injury.
This appliance must be properly grounded. If it should malfunction or break down, grounding provides a path of
least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord
having an equipment grounding conductor and ground outlet that is properly installed and grounded in accordance
with all local codes and ordinances. Do not operate the charger/analyzer with a damaged AC cord or plug. LXE
does not recommend the use of any extension cord with the MX5 Multi-Charger.
The MX5 Multi-Charger has been designed for use on a nominal 100 or 120 volt or nominal 220 or 240 volt circuit
and has a grounding attachment plug. The plug is an IEC configuration that is appropriate for your country and
regulations. Make sure that the appliance is connected to an outlet having a configuration similar to the plug. No
adapter should be used with this appliance. Improper connection of the equipment-grounding conductor can result
in a risk of electric shock.
Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly
grounded. Do not modify the plug provided with the appliance. If it will not fit in the outlet, have a proper outlet
installed by a qualified electrician.
Do not disassemble the MX5 Multi-Charger. It contains no user serviceable parts.