Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valves under the sink or at the main water
supply. Disconnect the supply lines. Remove the existing faucet from the
sink.
Clean and dry the surface area where the new faucet will be mounted.
2.
Confirm that the hole in sink and/or countertop is 1.3 in. - 1.5 in. to
accommodate the new faucet.
Remove the preassembled lock nuts (CC), rubber washer (AA) and metal
washer (BB) from the faucet body (A). Before installation, make sure the
flange (B) is on the bottom of the faucet body (A). Insert the faucet body (A)
through the mounting hole in the sink (2.1). From underneath the sink, secure
the faucet body (A) to the sink using the rubber washer (AA), metal washer (BB),
and lock nuts (CC). Use a wrench to tighten the lock nuts (CC).
Hardware used
AA
Rubber washer
BB
Metal washer
CC
Lock nut
3.
Remove the bottom gasket (3.1) and mounting nut (3.2) from the drain
assembly (C). Push the bottom gasket (3.1) down onto the top of the
mounting nut (3.2) and twist to attach together.
4.
Insert the drain assembly (C) into the drain hole in the sink (4.1). Ensure the top
gasket (4.2) rests securely between the top of the sink and the top of the drain
assembly (C).
x 1
x 1
x 2
4
1
2
AA
BB
CC
3
4
4.2
C
4.1
A
B
2.1
C
3.1
3.2
Publicidad
