Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND CLEANING
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish
and void your warranty.
TROUBLESHOOTING
PROBLEM
Faucet leaks underneath
handle.
Water does not completely
shut off.
Faucet leaks around
aerator.
Faucet has an improper
water pattern.
POSSIBLE CAUSE
Bonnet has come loose or O-ring on cartridge is
dirty or twisted.
Rubber valve seat is dirty, stuck, or broken.
The aerator is incorrectly fitted, dirty, or small parts
inside the aerator are improperly installed.
The aerator is dirty or small parts inside the aerator
are improperly installed.
1. Move the handle to the OFF position. Unscrew
the handle screw and remove the handle.
2. Tighten the bonnet by turning it clockwise. Move
the cartridge stem to the ON position. The leak
should stop draining out from around the
cartridge stem.
3. If the leak does not stop, shut off the water supply.
Remove the bonnet by turning it counterclockwise.
Lift out the cartridge valve. Inspect the larger
O-ring on the cartridge bonnet and the smaller
O-ring on the cartridge stem. Remove any debris
from the O-rings. If either O-ring is twisted,
straighten it. If either O-ring is damaged, replace
the cartridge by calling customer service.
4. Position the cartridge back into the faucet body.
Make sure the ridges on the two sides of the
cartridge bonnet fit into the grooves on the two
sides of the faucet body. Tightly screw the bonnet
onto the faucet body.
5. Reinstall the handle.
1. Shut off the water supply.
2. Remove the handle from the faucet body. Loosen
the bonnet by turning it counterclockwise. Lift
out the cartridge assembly.
3. Inspect the rubber valve seat in the faucet body.
If there is debris or brass scrap on the surface
of the seat, remove it. If the rubber seat is stuck
tightly in the water inlet hole, push it gently with
a fingertip so it moves up and down smoothly. The
spring (smaller end up) must be placed back
underneath the valve seat. If the rubber valve
seat is worn out or broken, replace the cartridge
by calling customer service.
4. Position the cartridge back into the faucet body.
Make sure the ridges on the two sides of the
cartridge bonnet fit into the grooves on the two
sides of the faucet body. Tightly screw the bonnet
onto the faucet body.
5. Reinstall the handle.
1. Remove the aerator cover from the spout by
turning it counterclockwise and remove the
aerator and gasket. Inspect the black rubber
gasket inside the aerator. The rubber gasket
should be flat.
2. Reinstall the gasket and aerator, then replace
and tighten the aerator cover on the spout.
1. Remove the aerator cover from the spout by
turning it counterclockwise and remove the
aerator and gasket.
2. Gently flush the small parts inside the aerator
to clear away any debris.
3. Reinstall the gasket and aerator, then replace
and tighten the aerator cover on the spout.
Ensure all parts are straight and flat.
6
SOLUTION
Publicidad
