Front Runner FAMP002 Instrucciones De Montaje página 3

2 FIT AND SECURE
2.1
2.2
2.3
3
FAMP002_REV_A01
Factory Roof Rails
10
9
11
4
FRONT OF VEHICLE
12mm
4mm
10mm
10mm
5
6
3
Before you start with the fitment of the
foot rails, you need to remove the
factory roof rails. Do this by unclipping
and removing the front and rear
end-caps of the roof rail. In the middle of
the roof rail you will see a small cover
plate, this will also need to be removed.
Now loosen the two bolts in front, one
bolt in the middle and 3 bolts at the rear
of the roof rail.
After you have removed all the bolts,
remove both the roof rails from the
vehicle.
Assemble the front and rear foot rail
(Items 1 and 2) with the joiner plate
(Item 7) and fasteners (Items 16, 11, 17
& 8) as shown.
Place a bead of sealant in and over each
hole in the roof, then place the spacers
(Items 3, 4, 5 & 6) over front, middle and
two rear holes as shown.
Place the foot rail that you assembled in
2.2 on the spacers and loosely secure it
with Items 9, 10 & 11 as shown.
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
13mm