Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
OVERVIEW
1.
Platter
Place your record here.
2.
45RPM Adaptor
This adaptor allows you to play 45RPM records.
3.
Tone arm
The fixed tonearm can be raised and lowered by
hand, or by pressing the raise / lower lever.
4.
Tone arm Lever
Raises and lowers the tonearm.
5.
33 / 45 / 78 RPM Switch
This switch controls the RPM of the turntable platter.
6.
Autostop Switch ON/OFF
This switch turns auto stop on or off. When the
automatic stop is enabled, the platform will start
rotating as soon as the tone arm is placed over the
record and will stop rotating when it has reached the
end of the record. Some vinyl records stop before
the end or do not stop when the end is reached. In
this case set Auto-stop to OFF.
7.
Power & volume control knob
To power on the record player, turn this knob clockwise until it clicks. When powered on, use this knob to adjust the
volume for the internal speakers and headphones. To turn off the record player, turn this knob counter clockwise until it
clicks.
8.
Arm Clip
This specially designed arm clip secures the tonearm while at rest or when not in use. The arm clip has been designed
to remain in the up position while unlocked.
9.
Cartridge with needle
When the turntable is not in use, it is recommendable to place the
removable protection cover on the stylus.
10.
USB port
Connector the USB power adapter with this USB port.
11. Line output
The audio from a playing vinyl record is sent to this line-level coaxial
audio output. This must not be connected to phono level devices.
OPERATION
1.
Connect the record player with the power adapter and plug the other end into a wall power outlet.
2.
Remove white protective needle cover by gently pulling towards the front of the unit.
3.
Place a vinyl record on the turntable platter and select the desired speed (33/45/78RPM)
according to the record.
4.
Open the tone arm clip to release the tone arm. Gently move the tone arm and put the cartridge
onto the desired position of the record and the turntable player starts to play.
5.
Turn the volume control knob clockwise to adjust the volume.
Noted: If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control is
turned OFF, record will NOT stop automatically when finished.
4
Publicidad
