Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTALLATION
1. Stick the adhesive strips to the back of the units. Remove only one side of strip protection.
2. Connect internal/external units with the supplied cable.
3. Stick both units to their final location.
4. Connect the internal unit to the power source and turn on the equipment.
5. Aim the microphone of the internal unit towards the operator.
6. Test and adjust the volume of both units if required.
Note: Units have been factory set to optimum levels. Do not modify them if it is not necessary.
4. ESPECIFICATIONS
Power Supply
Microphone
Operation temperature
Storage temperature
Protection class
Indicators
Controls
Consumption
Weigh
Dimensions
Accessories (included)
SIV-50 Versión 1.1
EXTERNAL UNIT
SIV-50
INTERNAL UNIT
12 Vdc
AEC+NR
0~40 ºC (5~90% HR)
‐20~60 ºC
MIC ON indicator
Volume control in internal/external unit
Internal microphone mute ON/OFF
0.5 kg (gross), 0.4 kg (net)
108 x 90 x 24 mm
1 x Power source 110‐240 Vac with 200 cm cable
4 x 3M Adhesive strip
1 x Bus cable 100 cm
1 x Windscreen
COUNTER INTERCOM
IP33
3 W
Page 2 of 3
Publicidad
