HAIRCUT TH25PRO Manual De Usuario página 26

EN
Apply 1 drop of lubricating oil on the 5 points shown (Fig. 5c).
Use only the oil supplied.
Install the blades by first inserting the rear part (Fig. 5d). Press the blades with
your thumbs where shown by the arrows to clip them in.
Switch the clippers on for a few seconds after lubricating them.
4 Servicing
4.1 Routine servicing
After using the clippers each time, clean the blades with the brush supplied
(Fig. 1-M).
If necessary, clean the body of the clippers with a cloth slightly dampened with
water or mild liquid soap. Never use abrasive products or solvents.
Clean the blades with an antibacterial spray. We recommend STERIL CLEANER
920- or 921- disinfectant and lubricant products.
Lubricate the blades at least once a day (see § 3.5 3.5).
4.2 Cleaning the blades
In the case of intensive use, clean the blades at least once a day.
Remove the blades as described in § 3.5.
Clean the inside of the blades with the brush supplied (Fig. 6a).
With your thumb, press on the 2 lugs (arrows) to move the fixed/mobile blades
(Fig. 6b). Eliminate all cutting debris and residues stuck between the blades.
Lubricate the blades and put back on the clippers as described in § 3.5.
26