Minebea Intec YDO02C-232 Instrucciones De Instalación página 11

Installing the Profibus Board
§ Fasten the RS-232 interface (including the connector board) into the applicable opening
on the new rear wall panel (bottom): Fasten the 2 screws in the connector mounting.
§ Connect the ribbon cable: Insert the ribbon cable for Profibus connection into the
applicable slot on the digital board (on the left in the illustration).
$ Where applicable, insert the ribbon cable for the RS-232 interface into the applicable slot
on the digital board (on the right in the illustration).
§ Attach the connecting cable:
– Securely attach the 4 conductors in accordance with their color coding.
– Plug the connector on the cable into the socket on the right.
§ Insert the ribbon cable for the Profibus connection into the applicable slot on the
interface module (YDO0.SW-DP).
$ Where applicable, insert the ribbon cable for the RS-232 interface into the applicable slot
on the connector board (on the left in the illustration).
§ Fasten the rear wall panel to the scale: Fasten the 6 screws.
Configuring the Profibus interface for operation
After installing the interface module in the scale and configuring it, configure the
Profibus interface for its intended function with the aid of the operating menu.
See the "Settings" section for this purpose. The "Configuration" section of the Signum
operating instructions contains further explanations about this.
YDO02C 11