Descargar Imprimir esta página

SNOWJOE 24V-X2-SB18-XR Manual Del Operador página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

1. The discharge chute can be adjusted 180 degrees by
rotating the chute crank. Rotate the chute control crank
clockwise to move the discharge chute to the left and
counterclockwise to move the chute to the right (Fig. 16).
Fig. 16
Discharge chute
2. The chute deflector on the top of the discharge chute
controls the height of the snow stream. Loosen the knobs
to raise or lower the deflector to the desired height of
snow you wish to throw. Tighten the knobs to secure the
deflector (Fig. 17).
Fig. 17
Deflector knob
Chute crank
13
m
WARNING
Make sure that the chute deflector snaps and locks
completely onto the discharge chute. An opening
between the discharge chute and the chute deflector
may allow foreign objects to be picked up by the
snow thrower and thrown in the direction of the
operator causing serious bodily injury.
• Do not advance the chute deflector too far
forward causing an opening to appear between
the deflector and discharge chute.
• Do not overtighten the knobs on the chute
deflector.
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
24V-X2-SB18-XR cordless snow blower, please
®
visit snowjoe.com or contact the Snow Joe
customer service center at 1-866-SNOWJOE (1-866-766-
9563).
m
WARNING!
Make sure to turn off the switch and
remove the batteries before performing any maintenance task
on your snow blower.
Lifetime Lubrication (Motor + Auger)
Lubrication is not necessary and may damage the unit.
The snow blower is lubricated for lifetime use at the factory
before shipment.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
3. After each snow removal session, run the snow blower
for a few minutes to prevent the collector/impeller from
freezing. Shut off the motor, wait for all revolving parts to
stop completely, and wipe residual ice and snow off the
unit. Rotate the chute deflector by the chute control crank
several times to remove any excess snow.
Proper Care for Batteries + Charger
m
WARNING!
To reduce the risk of injury, always unplug
the charger and remove the battery packs from the charger
before performing any maintenance task. Never disassemble
the battery packs or charger. Contact your Snow Joe
Sun Joe
dealer or the Snow Joe
®
service center for ALL repairs.
m
+ Sun Joe
®
®
+
®
+ Sun Joe
customer
®
®

Publicidad

loading