Publicidad
Idiomas disponibles
Idiomas disponibles
EN
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (18).
8. Make sure the chain tension pin hole (19) on the guide
bar fits correctly with the bolt.
18
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the chain cover knob when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
22
21
20
19
NOTE
English
7.4
FIT THE POLE SAW
2
Before using the pole saw, assembly is required. When
removed from the box, there are the three poles.
1. Insert the extension pole (2) into the handle pole (3) and
slide together. The tubes are oval-shaped and will only
install one way.
2. Push the extension pole into the lock sleeve (9) in the
handle pole and the press button (8) will lock into the
press button hole (10). Then use a wrench to secure the
lock nut (7).
3. Repeat this process to attach the extension pole to the
power head pole.
7.5
USE THE SHOULDER STRAP
60°MAXIMUM
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
7.6
CUTTING PREPARATION
Before you start to cut, make sure that
•
Wear heavy gloves for maximum grip and protection.
•
Maintain a proper grip on the machine during operation.
•
Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
•
Keep your body to the left of the chain line.
8
10
7
9
8
3
Publicidad
