Publicidad
Idiomas disponibles
Idiomas disponibles
F3 - 16 Bit operation
With this function you can reduce the projector-movement to 16 bit.
• Press the Function button and select „F3".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F4 - Demo operation
In the Stand Alone mode, the TMH-155 can be used without controller. Disconnect the TMH-155 from the
controller and call up the internal program (F4).
• Press the Function button and select „F4".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the TMH-155 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each TMH-155 correctly
and independently from any other fixture on the DMX data link.
If two, three or more TMH-155 are addressed similarly, they will work similarly.
Press the Up/Down-buttons for setting the desired starting address.
Controlling:
After having addressed all TMH-155, you may now start operating these via your lighting controller.
Note:
After switching on, the TMH-155 will automatically detect whether DMX 512 data is received or not. If the
data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights
up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TMH-155.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
30/63
51786410_V_2_4.DOC
Publicidad
