Publicidad
Idiomas disponibles
Idiomas disponibles
Technical data
Code
Description
Voltage
Frequency
Current
Power
Variable Speed
Miter cutting
Cutting Capacity
Duty Cycle
Conductors
Insulation Quality
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power requirements
WARNING
Tools with double insulation and reinforced insulation
eliminate the need of a grounded power cord with three prongs or a grounded
power connection.
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in
the line, resulting in power loss and overheating. The following table
shows the right size to use depending on cable's length and the ampere
capability shown in the tool's nameplate. When in doubt use the next
higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
50 minutes work per 20 minutes idle. Maximum 6 hours per day.
H05VV-F x 2C with insulating temperature of 194 °F
Class II
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
CALA-NX6-2
15349
Jig Saw
220 V
50 Hz / 60 Hz
3,2 A
1 Hp
800 - 3 000 strokes / min
0° - 45° left / right
Wood 4,7" | Aluminum 0,78" | Metal 0,39"
IP Grade
Power Cord Grips: Type Y.
Build Quality: Double Insulation.
Thermal Insulation on Motor Winding: Class E.
Authorized Service Center.
Extension gauge
from 6 ft to 49 ft
18 AWG( * )
16 AWG
14 AWG
8 AWG
IP20
|
higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3
Publicidad
