Publicidad
Idiomas disponibles
Idiomas disponibles
English
Turntable Operation
1. Rotate the On/Off Volume Knob to turn on the power.
2. Set the Speed Switch accordingly.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
5. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
6. Use the Tonearm Lever to lift up the tonearm.
7. Gently move the tonearm over the record where play is desired to begin. Set
the Tonearm Lever back to the down position, the tonearm will descend
slowly onto the record and begin to playback.
8. When the record is finished playing, the tonearm will automatically return to
its rest. Or to suspend the playback, use the Tonearm Lever again to raise
the tonearm and return it to the Tonearm Rest. Release the lever to lower the
tonearm back to its rest.
9. Lock the Tonearm Clip to secure the tonearm.
Pitch Adjustment
There are two sets of strobe dots at the edge of the platter, upper set for AC
frequency 50Hz and bottom set for AC frequency 60Hz.
When the platter is spinning, observe the strobe dots on the edge of the
platter. As illuminated by the light coming from the strobe illuminator, if the
appropriate row of strobe dots appears to be stationary, the platter is spinning
at the precise rated speed.
If the dots appear to be moving to the right, the platter is spinning below rated
speed; if they appear to be moving to the left, the platter is spinning above
rated speed.
7
Publicidad
