Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads to clean the exterior of the equipment.
These can damage the finish.
NOTICE: Heating elements do not need to be cleaned. Crumbs and
food debris will burn off. Over time the heating elements
may develop a chalky appearance, but this will not impact
performance.
PREVENTATIVE MAINTENANCE
Contact an authorized service agent for a professional cleaning of the components.
TROUBLESHOOTING
Problem
Toaster does not heat and the
conveyor belt does not move.
Conveyor Bagel and Bun Toasters, 1400 Slices Per Hour* Operator's Manual – Model JT3BH
Might be Caused By
Toaster is not plugged in.
Power knob setting is incorrect.
The wall breaker may be tripped.
The reset may be tripped.
Daily Cleaning
1. Before turning off the equipment and with the conveyor rotating,
watch the conveyor belt for food debris.
2. When the food debris reaches the front of the conveyor, rotate the
power knob to the OFF position.
3. Wait for the fan to stop running. Unplug the equipment.
4. Let the equipment cool completely.
5. When the equipment is cool, use a brush or scrub pad to remove the
food debris.
6. To clean the exterior, use a soft cloth dipped in hot soapy water to
wipe the exterior and fan air intake under the equipment. If needed,
wipe the fan intake area with degreaser to prevent long term build
up.
7. Empty and clean the crumb tray(s).
Course of Action
Plug in the toaster.
Rotate the power knob to the ON (|) position.
1. Inspect for tripped breaker.
2. Reset the breaker.
3. If the breaker was not tripped, inspect the toasting chamber for
broken heater tubes
For broken tubes, contact Vollrath Technical Services.
Look under the toaster to see if an object is preventing the fan
blades from turning.
1. Rotate the heat control knobs to the OFF position.
2. Rotate the power knob to the OFF (O) position.
3. Unplug the toaster.
4. Wait 30 minutes for the toaster cool.
5. Remove the object.
6. Plug in the toaster.
7. Rotate the power knob to the ON (|) position.
8. Press the reset button. You should hear and feel the button
reset. The toaster should start to operate.
9. If the problem persists call Vollrath Technical Services.
3
Publicidad
