Bosch GWS18V-10 Instrucciones De Funcionamiento Y Seguridad página 32

To avoid accidents, always disconnect the battery pack from tool before ser-
vicing or cleaning.
Service
NO
PARTS INSIDE. Preventive
maintenance performed by un au thorized per-
sonnel may result in misplacing of internal
wires and components which could cause se-
rious hazard. We recom mend that all tool ser-
vice be performed by a Bosch Factory Service
Center or Authorized Bosch Service Station.
Batteries
Be alert for battery packs that are nearing their
end of life. If you notice decreased tool perfor-
mance or significantly shorter running time be-
tween charges then it is time to replace the bat-
tery pack. Failure to do so can cause the tool
to operate improperly or damage the charger.
Tool Lubrication
Your Bosch tool has been properly lubricated
and is ready for use.
Do not use attachments/accessories other than those specified by Bosch. Use
of attachments/accessories not specified for use with the tool described in this
manual may result in damage to tool, property damage, and or personal injury.
Do not use Type 11 abrasive (cup) wheels with this tool. This tool is not de-
signed for use with type 11 (cup) abrasive grinding wheels.
Standard equipment
• Type B (27) grinding wheel guard
• Quick-clamping nut
• Backing flange
• Side handle
• Lock nut wrench
Maintenance
USER SERVICEABLE
Accessories
Motors
The motor in your tool has been engineered for
many hours of dependable service. To maintain
peak efficiency of the motor, we recommend it
be examined every six months. Only a genuine
Bosch replacement motor specially designed
for your tool should be used.
Cleaning
parts. Some of these are: gasoline, carbon tet-
rachloride, chlorinated cleaning solvents, am-
monia and household detergents that contain
ammonia.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through opening.
Accessory Storage and Maintenance
Store accessories in a cool dry place and avoid
freezing. Before use check accessory for cracks
and fractures, do not use if damage is suspect-
ed.
Optional accessories and attachments
• Lock nut
• Type A (1A/41) Cutting Wheel guard
• Hand shield
• Backing pad assembly
• Type E concrete surface grinding shroud
• Type F concrete and/or masonry cutting guards
-32-
Certain cleaning agents and
solvents damage plastic