Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Verifying the transformer
1
power rating
Power must be supplied from a 16 volt AC, 10 or 15 watt
transformer.
WARNING: This doorbell requires a low voltage electrical
connection. Do not connect directly to 120V AC.
2
Removing the existing doorbell
Remove the cover from the existing doorbell
and label all wires with masking tape before
disconnecting:
"F" - Front door push button wire
"T" - Transformer wire
"R" - Rear door push button wire (if
applicable)
Disconnect all wires from existing doorbell and
remove doorbell from mounting surface.
3
Mounting the doorbell base
Route the wires through the wire entrance hole
in the doorbell base (B).
Using the "UP" arrow indicator, place the
doorbell base (B) against the wall and mark
the two screw hole locations.
Drill two 7/32 in. pilot holes and insert wall
anchors (BB).
Attach the doorbell base (B) to the mounting
surface using the two screws (AA) and tighten
securely.
4
Wiring the doorbell
Connect the doorbell wires to the doorbell
base (A):
Wire "F" to screw terminal "FRONT"
Wire "T" to screw terminal "TRANS"
Wire "R" to screw terminal "REAR"
Press the doorbell cover (A) onto the doorbell
base (B).
NOTE: To remove doorbell cover (A) after doorbell
base (B) is mounted, firmly grasp doorbell cover (A) and
pull.
NOTE: Push button(s) wired to the screw terminal
marked "FRONT" will play the "Ding-Dong" sound. Push
button(s) wired to the screw terminal marked "REAR" will
play the "Ding" sound.
5
Please contact 1-844-760-3644 for further assistance.
T
O N
F R
S
A N
T R
A R
R E
O N
T
F R
A N
S
T R
A R
R E
AA
T
O N
F R
S
A N
T R
A R
R E
HAMPTONBAY.com
B
B
Publicidad
