Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSMISSION GEARS
LUBRICATION
The transmission gears in the gear case
need to be lubricated periodically with
gear grease. Check the gear case grease
level about every 50 hours of operation by
removing the sealing screw on the side of
the case.
If no grease can be seen on the flanks of
the gear, follow the steps below to fill with gear grease up to 3/4 capacity.
Do not completely fill the transmission gears.
1. Hold the brush cutter attachment so that the sealing screw is facing upwards
(Fig. 15).
2. Use the hex tip of the multi-function wrench to loosen and remove the sealing
screw.
3. Use a grease syringe (not included) to inject some grease into the screw hole.
4. Tighten the sealing screw after injection.
STORING THE UNIT
1. Remove the battery pack from the
power head.
2. Wear heavy gloves to clean the
machine thoroughly.
3. Mount the blade sheath onto the
blade for safe storage (Fig. 16).
4. Remove the brush cutter attachment
from the power head and place the
end cap onto the attachment shaft terminal.
5. Store the unit in a dry, well-ventilated area, locked-up or up high, out of the reach
of children. Do not store the unit on or adjacent to fertilizers, gasoline, or other
chemicals.
BRUSH CUTTER ATTACHMENT — BCA1220/BCA1220-FC
15
Sealing Screw
16
31
Publicidad
