HAMPTON BAY 99101 Guía De Uso Y Cuidado

PACKAGE CONTENTS
A
A - Solar head
1000mAh Ni-Mh
rechargeable battery
Pre-Installation
□ Read all instructions before assembly and installation.
□ Inspect each part for defects that may have occurred during shipping.
□ Keep your receipt and these instructions for proof of purchase.
CHOOSING THE RIGHT LOCATION
Install your solar light in a location with full, direct sunlight. Do not install in shaded areas as these areas will not allow the batteries to fully charge and will reduce
the nighttime operating hours for your light. Ensure that the installation location is away from other nighttime light sources such as street or porch lamps. These light
sources may prevent your solar light from automatically turning on.
HOW SOLAR WORKS
The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries. At night, the
solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location, daily weather conditions, and
season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.
Installation
1
Preparing for installation
NOTE: The solar panel will turn the
light on automatically at dusk.
□ FOR FIRST TIME USE: Twist and remove
the solar head (A) from the bollard housing
(F). Remove the pull-tab from the battery
cover (C).
□ Slide the switch on the battery cover (C)
underneath the solar head (A) to the ON or
FLAME position depending on the desired
function.
□ Replace the solar head (A) on the bollard
housing (F), twist to lock into place.
A
Use and Care Guide
AMBROSE
Solar Flicker Flame Bollard Light
B
B - AA 1.2V C - Battery cover
(pre-installed)
C
(underneath
top cover)
C
Switch
C D
D - Flame bulb
(pre-installed)
2
Installing the solar light in the ground
NOTE: Do not use a hammer. If the ground is hard, use
water to soften it or a trowel to loosen the soil.
□ Firmly slide the stake (G) into the bottom of the bollard housing (F).
A
□ Push the assembly firmly into the ground.
F
E
E - Housing F - Bollard housing
(pre-installed)
F
G
Please contact 1-855-HD-HAMPTON for further assistance.
Item #1007 976 440
Model #99101
F
G
G - Stake
HAMPTONBAY.COM